Issue 3.0
5-72 Installing DT Series Digital and IP Multiline Terminals
5.2.4.1 Installing the 12LK-L KIT
1. Turn multiline terminal upside down.
Only one 12LK-L KIT can be attached to the DTL/ITL
multiline terminal.
2. Pry the right side panel from the multiline terminal.
3. From the lower left or right corner, pry the Line Key Panel
from the multiline terminal (refer to Figure 5-74 Removing
the Line Key Panel).
To prevent possible damage to the 12LK-L KIT or
the DTL/ITL multiline terminal during
installation or removal, disconnect the line cord/
LAN cable and the
AC/DC adapter from the DTL/ITL multiline
terminal.
Figure 5-74 Removing the Line Key Panel
To Next Page
Loading...
