Issue 3.0
SV9100 System Hardware Manual 9-135
4. Push the two stopper tabs through the slots to separate the tilt leg
from the leg support.
5. Lay the tilt leg and the leg support flat.
6. Press the two tabs locking the legs to the multiline terminal and pull
the legs toward you, lifting to remove (refer to Figure 9-119 Remove
Legs From Multiline Terminal).
7. Disconnect serial connection cord from terminal body. Leave cord
connected to the cradle unit.
8. Push latch to right to unlock the cradle unit. Then push the cradle unit
forward to separate from the terminal body.
Figure 9-118 Separate Tilt Leg from Leg Support
Figure 9-119 Remove Legs From Multiline Terminal
To Next Page
Loading...
