NEC Univerge SV9100 - Figure 5-49 Removing the Hanger Hook on a DT Series Terminal; Figure 5-50 Sliding the Hanger Hook into Position

Issue 3.0
5-56 Installing DT Series Digital and IP Multiline Terminals
4.7 Wall Mounting the Multiline Terminal
You can wall mount a DT series multiline terminal using the base cover or an
optional wall mount unit. A wall mount unit must be used if adapters are installed
on the multiline terminal.
 When optional adapters are used, the multiline terminal must be installed on the
wall using the WM-L UNIT (refer to 5.2.13 WM-L UNIT on page 5-94).
4.7.1 Wall Mounting a Multiline Terminal using the Base Plate
4.7.1.1 Adjusting the Hanger Hook
1. Remove the hook from the unit.
2. Turn the hook with the tab toward the top.
3. Slide the hook until it glides into position forming the hanger
hook for the handset.
Figure 5-49 Removing the Hanger Hook on a DT Series
Terminal
Hanger Hook
Figure 5-50 Sliding the Hanger Hook into Position