NEC Univerge SV9100 - Table 5-4 Firmware Compatibility Matrix

Issue 3.0
5-6 Installing DT Series Digital and IP Multiline Terminals
Table 5-3 Terminal and Adapter Compatibility (DT400/DT800)
Terminal
Adapter Unit
ADA-L APR-L
ILPA

BHA-Z BCA-Z
Digital Terminals: DT400
DTZ-2E-3 (BK) TEL
—————
DTZ-6DE-3 (BK) TEL
—————
DTZ-12D-3 (BK)/(WH) TEL

—

DTZ-24D-3 (BK)/(WH) TEL

—

DTZ-8LD-3 (BK)/(WH) TEL

—

IP Terminals: DT800
ITZ-8LD-3 (BK) TEL

—

—

ITZ-12D-3 (BK)/(WH) TEL

—

—

ITZ-24D-3 (BK)/(WH) TEL

—

—

ITZ-12CG-3 (BK)/(WH) TEL

—

—

ITZ-12DG-3 (BK)/(WH) TEL

—

—

ITZ-8LDG-3 (BK)/(WH) TEL

—

—

Console:
DCZ-60-2 (BK)/(WH) CONSOLE
———

—

= When the ILPA-R unit is used, 1000 BASE-T is not available.
Table 5-4 Firmware Compatibility Matrix
BCH-L Unit Lot Number
xxxDxx or lower xxxExx or higher
Terminal
Lot
Number
DT-330
xxx I xx or lower
(Version 8.10 and 1, E0 or lower)
Supported Supported
xxxJxx or higher
(Version 2.20 or higher)
Not supported Supported
 BCH Support may differ based on terminal firmware. To verify both DT-330 terminal and BCH-L
Unit firmware, hold down keypad buttons 1, 2 and 3 while plugging the line cord into the terminal.