Issue 3.0
SV9100 System Hardware Manual 9-143
3. Lower the tilt leg to the first position (refer to Figure 9-131 Separate
Tilt Leg from Leg Support).
4. Push the two stopper tabs through the slots to separate the tilt leg
from the leg support.
5. Lay the tilt leg and the leg support flat.
6. Press the two tabs locking the legs to the multiline terminal and pull
the legs toward you, lifting to remove (refer to Figure 9-132 Remove
Legs From Multiline Terminal).
Figure 9-131 Separate Tilt Leg from Leg Support
Figure 9-132 Remove Legs From Multiline Terminal
To Next Page
Loading...
