Issue 3.0
6-8 Installing SV9100 Cordless Telephones
2.6 Mounting the Base Directly to the Wall
If a standard wall plate is not available, mount the telephone directly on the wall.
Before mounting the telephone, consider the following:
Select a location away from electrical cables, pipes, or other items behind the
mounting location that could cause a hazard when inserting screws into the
wall.
Make sure the wall material can support the weight of the base unit.
Use #10 screws with anchoring devices suitable for the wall material where the
base unit will be placed.
To mount the telephone:
1. Insert two mounting screws 3-15/16 inches apart. Allow about 3/16 of an
inch between the wall and screw heads for mounting the telephone.
2. Plug in and secure the AC adapter.
3. Plug the AC adapter into the base unit.
4. Plug one end of the short telephone cord into the LINE jack on the base
unit. Then plug one end of an NEC multiline terminal into the PHONE jack.
Place the telephone cords inside the molded channels on the bottom of the
wall mount stand (refer to Figure 6-12 Placing the Telephone Cords Inside
the Wall Mount Stand on page 6-9).
Figure 6-11 Inserting Screws into the Wall for Wall Mounting the Telephone
To Next Page
Loading...
