NEC Univerge SV9100 - Figure 6-3 Connecting Telephone Cords to the Telephone Jack

Issue 3.0
SV9100 System Hardware Manual 6-3
2.3 Connecting the Telephone Cords
When connecting the telephone cords, observe the following precautions.
To connect the telephone cords:
1. Connect the cord from the telephone jack to the Line In on the D
term
Cordless DECT.
2. Connect a qualified NEC digital multiline terminal to the D
term
Cordless
DECT (refer to Figure 6-4 Connecting the D
term
Cordless DECT to the
Multiline Terminal on page 6-4).
WARNING
❍ Never install telephone wiring during a lightning storm.
❍ Never touch bare telephone wires or terminals unless the telephone
line is disconnected at the network interface.
❍ Use caution when installing or modifying telephone lines.
Figure 6-3 Connecting Telephone Cords to the Telephone Jack