NEC Univerge SV9100 - Figure 5-96 Remove Side Panel from Multiline Terminal

Issue 3.0
SV9100 System Hardware Manual 5-89
5.2.9.1 Installing the DCL-60-1/DCZ-60-2 CONSOLE
1. Remove both plastic panels from the front of the multiline
terminal.
2. Turn multiline terminal upside down.
 Only one DCL-60-1/DCZ-60-2 CONSOLE can be
attached to the DT Series multiline terminal.
3. Pry the side panel from the multiline terminal.
4. Turn the multiline terminal button side up.
5. Fit the projections of the supplied bracket into the side of the
multiline terminal.
WARNING
To prevent possible damage to the DCL-60-1/
DCZ-60-2 CONSOLE or the DT Series multiline
terminal during installation or removal,
disconnect the line cord/LAN cable and the AC/
DC adapter from the DTL/ITL multiline terminal
TIP
❍ If a “Digital Port Connection” is used, one
telephone can support a maximum of 32 DSS
Consoles.
❍ If connected to an IP phone as a side option, a
maximum of one DSS Console is supported
per telephone.
Figure 5-96 Remove Side Panel from Multiline Terminal
Side Panel