NEC Univerge SV9100 - Figure 5-43 Adjust Height of DT Series Terminal

Issue 3.0
5-52 Installing DT Series Digital and IP Multiline Terminals
4.5 Adjusting the Height on the Multiline Terminal
The height of the DT series multiline terminals can be adjusted by moving the legs
attached to the bottom of the terminal.
1. Turn telephone over (button side down).
2. Adjust legs to desired height (refer to Figure 5-43 Adjust Height of DT Series
Terminal).
3. Turn telephone over (button side up).
Figure 5-43 Adjust Height of DT Series Terminal