NEC Univerge SV9100 - Figure 6-42 Wall Mount Spacing Guide BCH-L (BK) UNIT

Issue 3.0
6-34 Installing SV9100 Cordless Telephones
4.4.2 Wall Mounting the Bluetooth Cradle
Clearances required for installing the Bluetooth cradle are shown below.
Avoid mounting the cradle on a plaster-board wall, but before mounting the
cradle on a wall, check that the wall can support the weight of the telephone
and withstand the load from pulling the telephone during operation.
1. Attach two wood screws to the wall.
 Keep a clearance of about 0.08” (2mm) between each wood screw
and the wall (refer to Figure 6-43 Installing Wood Screws on
page 6-35).
WARNING
To prevent possible damage to the BCH-L (BK) UNIT due to
falling, NEC recommends installing the unit in a firm
position so it cannot fall because of its own weight.
Figure 6-42 Wall Mount Spacing Guide BCH-L (BK) UNIT