Issue 3.0
5-108 Installing DT Series Digital and IP Multiline Terminals
SECTION 7 UT880 IP TELEPHONE
The UT880 is an IP desk phone for use on the SV9100 system. This phone is
powered by Power over Ethernet (PoE) reducing the need for power adapters
allowing for a clean installation. In addition, headsets for those users who frequently
make long calls are supported for comfort.
7.1 Powering the UT880
The UT880 can only be powered using Power over Ethernet (PoE) 802.3af.
7.2 Updating the UT880 System Firmware
UT880 firmware is updated via the Internet from the settings page of the phone.
To update the firmware go to the desk top of the UT800, choose Settings and
select About Tablet. Choose System updates then Check now. If an update is
available you will be prompted to download the update. Once the download has
finished you will be prompted to apply the update. If no update is available the
phone will state your system is up to date.
7.3 UT880 Platform Information
Refer to Table 5-20 UT880 Platform Information for UT880 specifications.
Table 5-20 UT880 Platform Information
Main Item Sub Item Specification
System
CPU ARM Cortex-A9 Dual MicroProcessor 512KB L2 Cache
Flash Memory 4Gbit NAND Flash
SDRAM Memory 1Gbit DDR3 SDRAM
CODEC G.711u/a, G.729, G.722, H.264
Voice
Interface
Handset Supported
Headset Supported
Speaker Phone Supported
Network
LAN 10/100/1000Bast-T with Auto MDIX
PC 10/100/1000Bast-T with Auto MDIX
Bluetooth BT V2.1 + EDR
Display &
Keypad
LCD 7” TFT LCD (1024x600)
LED Message indicator support (3EA)
Keypad Full Touch
To Next Page
Loading...
