NEC Univerge SV9100 - Figure 6-49 Separate Tilt Leg from Leg Support

Issue 3.0
6-38 Installing SV9100 Cordless Telephones
SECTION 5 BLUETOOTH HUB ADAPTER
5.1 Bluetooth Hub Adapter (BHA) Features
The BHA-L UNIT adapter connects a Bluetooth device to a multiline terminal. The
BHA-L UNIT cannot be connected to the DTL-2E-1, DTL-6DE-1 or DTL-12E-1
telephone.
5.1.1 Installing the BHA-L UNIT
1. Turn multiline terminal upside down.
2. Unplug the line cord and handset cord from the multiline terminal.
 Only one BHA-L UNIT can be attached to the DTL multiline
terminal.
3. Lower the tilt leg to the first position (refer to Figure 6-49 Separate Tilt
Leg from Leg Support).
4. Remove the connector cover (rubber) from the bottom of the multiline
terminal (see Figure 6-50 Removing the Connector Cover on page
6-39).
IMPORTANT
Before installing or removing the BHA-L UNIT, remove the
line cord and the AC adapter from the outlet.
Figure 6-49 Separate Tilt Leg from Leg Support
Stoppers
Tilt Leg