Issue 3.0
7-20 Installing SV9100 Wireless Telephones
3.2 Base Station Wall Mounting Installation
1. Hold the base in its final location and mark the screw location based on the
measurements shown.
Red Blinking Factory reset warning. A factory reset has been
initiated or is in progress.
Red Blinking No Ethernet connection available
OR
handset registration failed.
Red Flickering Stage in base flash memory rewrite at the end of the
base firmware update.
Red Steady On Critical error. Contact technical support.
Table 7-8 Base Station LED States and Meanings (Continued)
Color State Meaning
Ensure the wall can support the weight of the base station.
Figure 7-19 Base Station Dimensions
To Next Page
Loading...
