NEC Univerge SV9100 - Figure 9-113 Separate Tilt Leg from Leg Support; Figure 9-114 Bottom Option Interface Knockout

Issue 3.0
SV9100 System Hardware Manual 9-131
4. Push the two stopper tabs through the slots to separate the tilt leg
from the leg support.
5. Lay the tilt leg and the leg support flat to expose APR-L UNIT
compartment.
6. Carefully pry loose the knockout covering the bottom option interface
(refer to Figure 9-114 Bottom Option Interface Knockout).
7. Using the exposed Bottom Option Interface as a guide, install the
APR-L UNIT in the bottom of the DTL multiline terminal. Push down
until left and right tabs are seated (Refer to Figure 9-115 Install APR-L
UNIT on page 9-132).
Figure 9-113 Separate Tilt Leg from Leg Support
Stoppers
Tilt Leg
Figure 9-114 Bottom Option Interface Knockout
Knockout
Bottom Option
Interface