NEC Univerge SV9100 - Table 4-27 GCD-2 BRIA LED Indications

Issue 3.0
SV9100 System Hardware Manual 4-67
3. Connect the cable from the NT1 Network Termination cable to the
CN7 or CN8 connector on the GCD-2BRIA blade and/or GPZ-2BRIA
daughter board. (Refer to Figure 4-23 GCD-2BRIA Blade on page
4-65 for the location of the connectors on the blade.)
5.3.3 LED Indications
LED indications for the GCD-2BRIA are listed in Table 4-27 GCD-2BRIA
LED Indications. Each LED is listed with its associated function and LED
and Operational status.
Refer to Figure 4-23 GCD-2BRIA Blade on page 4-65 for the location of the
LEDs on the blade.
Table 4-27 GCD-2BRIA LED Indications
LED Indication
Operation Status Remarks
Live LED
(Green)
Busy LED (Red)
On
On System Initializing
–
Flash (1s) On The assignment of the unit is refused.
When you exceed the system
capacity.
When the main software version is
not matched.
Flash (1s) Trouble found during self-diagnostics.
–
Flash
(100ms)
On
Normal
Operation
A Channel is busy (use
another from CH1 ~ CHx).
–
Off
All channels are idle. –
Off
On
Unit Busy
A Channel is busy (use
another from CH1 ~ CHx).
–
Off
All channels are idle. –
Flash 80ms (On/
Off) x 3/400ms
Off
Downloading firmware.
–