NEC Univerge SV9100 - Figure 6-33 Remove Legs from Multiline Terminal; Figure 6-34 Detach Cradle from Multiline Terminal

Issue 3.0
SV9100 System Hardware Manual 6-29
7. Remove the side panel.
8. Disconnect serial connection cord from terminal body. Leave cord
connected to the cradle unit.
9. Push the latch to the right to unlock the cradle unit. Then push the
cradle unit forward to separate it from the terminal body (see Figure
6-34 Detach Cradle from Multiline Terminal).
Figure 6-33 Remove Legs From Multiline Terminal
Figure 6-34 Detach Cradle from Multiline Terminal