NEC Univerge SV9100 - Table 8-2 SIP Conference Max Programming Options

Issue 3.0
8-4 Installing SV9100 Conference Solutions
2.4 Programming Options
To enter Programming mode, press and hold REDIAL until a diamond arrow is
displayed on the LCD. Then press the applicable key and follow the instruction in
Table 8-2 SIP Conference Max Programming Options.
Table 8-2 SIP Conference Max Programming Options
Menu Option Key Programming
Ringer Melody
1
Press REDIAL. The current melody selection flashes.
Press 1~5 to change melody. Press REDIAL to save the
selection.
Dialing Mode
2
Press REDIAL. The current dialing selection flashes. Press
1 for tone or 2 for pulse. Press REDIAL to save the
selection.
Flash Duration
3
Press REDIAL. The current duration flashes. Press 1~5 to
select duration as follows:
1 = 600ms
2 = 300ms
3 = 150ms
4 = 100ms
5 = 80ms
Press REDIAL to save the selection.
Local Number

4
Press REDIAL. Enter the telephone number that you want
displayed on the LCD in standby mode. Press REDIAL to
save the number.
Conference

5
Press REDIAL. Enter the telephone number you want the
conference key to dial. Press REDIAL to save the number.
Service

6
Press REDIAL. Enter the telephone number you want the
O key to dial. Press REDIAL to save the number.
 Press CLEAR to return the previous menu. Press and hold to exit programming without
saving changes.
* Press and hold 1 to enter hyphen or * to enter a space in the number.
Press CLEAR before entering a new number.