Issue 3.0
5-66 Installing DT Series Digital and IP Multiline Terminals
7. Plug ribbon cable on back of 8LKD (LD)-L UNIT into
connector until pressure is felt.
8. Press down on the black bar to lock the cable into place
(refer to Figure 5-64 Ribbon Cable Installed on page 5-66).
9. Align the projections on the bottom of the 8LKD (LD)-L UNIT
with the guide holes on top of the multiline terminal.
10. Slide the 8LKD (LD)-L UNIT toward the keypad buttons until
snug (refer to Figure 5-65 8LKD (LD)-L UNIT Installed).
Figure 5-64 Ribbon Cable Installed
Projection
(One Each Side)
Guide
Guide
Figure 5-65 8LKD (LD)-L UNIT Installed
To Next Page
Loading...
