Issue 3.0
3-12 Installing the SV9100 Chassis
5. Align the GPZ-BS10 blade with the guides located in the
expansion bay.
6. Slide the GPZ-BS10 blade into the chassis until resistance
(back plane) is felt.
7. Gently push until the blade seats and install the supplied
retaining screw.
8. Align the door tabs with hinges and reattach the cover (refer
to Figure 3-11 GPZ-BS10 Blade Installed on page 3-13).
Figure 3-9 GPZ-BS10 Blade Guides
Figure 3-10 Installing GPZ-BS10 Blade in Expansion Bay
To Next Page
Loading...
