Issue 3.0
SV9100 System Hardware Manual 1-5
Universal Blade Slot (9.5” Gateway and Base Chassis)
A 9.5” Gateway (CHS2UG GW-US) or Base (CHS2UG B-US) chassis is used
for legacy line/trunk blades. The 9.5” chassis provides three universal slots.
Also, the universal slots can be used for special application blades without
complicated limitation. This makes for easy quotation and installation.
Universal Blade Slot (9.5” Base and Expansion Chassis)
A 9.5” Base (CHS2UG B-US) and Expansion (CHS2UG E) chassis is used for
legacy line/trunk blades. One combined chassis provides six universal slots and
one expansion slot. Also, the universal slots can be used for special application
blades without complicated limitation.
Universal Blade Slot (19” Chassis)
A 19” (CHS2UG-US) chassis is used for legacy line/trunk blades. One 19”
Chassis provides six universal slots and one expansion slot. Also, the universal
slots can be used for special application blades without complicated limitation.
Easy Installation (Front Cabling and Enhanced O&M Tool)
Cable connectors (RJ-45 or RJ-61) are located on the front panel of each
chassis and blade. This increases efficiency of the cabling work. Also, PCPro
provides an enhanced user interface. A Quick Setup tool provides easy setup
(system data programming) for a basic system configuration in shorter time.
SECTION 2 EQUIPMENT LIST
The following tables list all equipment for the SV9100 system.
Table 1-1 Chassis Equipment List
Equipment Name Equipment Description
CHS2UG-US 19” Chassis (6-slot)
CHS2UG GW-US 9.5” Gateway Chassis (3-slot)
CHS2UG B-US
9.5” Base Chassis (3-slot)
CHS2UG E
9.5” Expansion Chassis (3-slot)
Table 1-2 Chassis Installation Equipment List
Equipment Name Equipment Description
CHS2UG MOVABLE WALL MOUNT
KIT
Movable Wall Mount Set for CHS2UG B-US and CHS2UG E
chassis
CHS BASE UNIT Floor Mount Set for all chassis (CHS1UG-US and
CHS2UG-US)
To Next Page
Loading...
