NEC Univerge SV9100 - Figure 3-30 Installing the Expansion Bracket; Figure 3-31 Remove Expansion Chassis Cover

Issue 3.0
3-26 Installing the SV9100 Chassis
3. Match the Joint Bracket with screw holes A, B, C and D on the side of
the Base Chassis (refer to Figure 3-30 Installing the Expansion
Bracket), and install with four M4 x 14 screws.
4. From the Expansion Chassis, loosen and remove screws d and e
from the top cover (refer to Figure 3-31 Remove Expansion Chassis
Cover). Slide cover toward rear of chassis and lift to remove.
Figure 3-30 Installing the Expansion Bracket
Figure 3-31 Remove Expansion Chassis Cover