NEC Univerge SV9100 - Figure 9-108 ADA-L out Jack Connection

Issue 3.0
SV9100 System Hardware Manual 9-127
13.3.3 ADA-L UNIT Connection
13.3.3.1 ADA-L UNIT Connection for Recording Only
10. Set the ADA-L UNIT DSW switches (Refer to Figure 9-104
ADA-L UNIT on page 9-123).
11. Using the mini-plug connection cord, connect the ADA-L
UNIT Out jack to the cassette recorder MIC jack (Refer to
Figure 9-108 ADA-L OUT Jack Connection on page 9-127)
.
13.3.3.2 ADA-L UNIT Connection for Sending Recorded Calls to
the Telephone
1. Set the ADA-L UNIT DSW switches (see Figure 9-104
ADA-L UNIT on page 9-123).
CAUTION
The mini-plug connection cord should not use an attenuator. Use a
monaural (single ring) mini-plug connection for normal recording.
NOTE

❍ Set DSW 6 to ON.
❍ DSW switch 5 is used to change the output
level from the OUT jack of the ADA-L
UNIT
(On = Low, Off = High).
Figure 9-108 ADA-L OUT Jack Connection
NOTE

❍ Set DSW 6 to ON.
❍ When sending recorded calls to the
telephone, set DSW switch 1 to ON.