NEC Univerge SV9100 - Table 8-1 SIP Conference Max Keypad Functions

Issue 3.0
SV9100 System Hardware Manual 8-3
2.2 Connecting and Charging the Batteries
To connect and charge the batteries:
1. Slide the cover off the battery compartment on the bottom of one pod.
2. Connect the battery pack plug in the port in the compartment and install the
battery pack.
3. Slide the cover back in place.
4. Connect the power supply/charger to the conferencing pod and plug it in an
electrical outlet.
5. Repeat steps 1~4 for the other pod.
2.3 Keypad Functions
Refer to Table 8-1 SIP Conference Max Keypad Functions.
IMPORTANT
Charge batteries for 15 hours prior to first use.
Table 8-1 SIP Conference Max Keypad Functions
Key Function
ON/OFF key
(telephone icon)
Press to activate the telephone and access dial tone. Press
again to hang up and return to standby mode.
PHONEBOOK (book
icon)
Press to dial stored numbers. Press and hold two seconds to
enter Phonebook Edit mode.
REDIAL (circular arrow
icon)
Press once to dial the last number called. Press and hold two
seconds to enter Program mode.
CONFERENCE (three
person icon)
Press to dial the conferencing service provider. This feature
must be programmed.
FLASH (lightning flash
icon)
Press to enable call forwarding, call waiting, or three-way
calling when supported by telephone service.
CLEAR (vertical line
and left arrow icon)
Press to clear the last digit entered or press and hold to clear all
numbers.
Press to exit programming mode.
VOLUME (loud and dim
speaker icons)
Press during call to adjust call volume or press while telephone
is ringing or in standby mode to adjust ringer volume.
MUTE (mic with
diagonal line icon)
Press to mute sound.