NEC Univerge SV9100 - Figure 3-80 Install Screws (Small Batt Box); Figure 3-81 Wall Mount

To Next Page

To Previous Page

Issue 3.0

3-66 Installing the SV9100 Chassis

4. Install the four screws previously removed.

5. Align the brackets with the holes on the sides of the 9.5 inch

Basic Chassis (CHS2UG B-US). Install 2 M4 x 14 screws.

Figure 3-80 Install Screws (Small Batt Box)

Figure 3-81 Wall Mount – Upper Side (Small Batt Box)

NEC Univerge SV9100 - Figure 3-80 Install Screws (Small Batt Box); Figure 3-81 Wall Mount - Upper Side (Small Batt Box)