NEC Univerge SV9100 - Table 4-34 GCD-PRTA RJ-45 Cable Connector Pin-Outs; Table 4-35 GCD-PRTA RJ48 C Connector Pin-Outs

Issue 3.0
4-80 Installing the SV9100 Blades
5.6.4 Connectors
Table 4-34 GCD-PRTA RJ-45 Cable Connector Pin-Outs shows the pin-outs
for the T-Bus RJ-45 connections. Figure 4-26 GCD-PRTA Blade on page
4-75 shows the location of the connectors on the PRT blade.
Table 4-35 GCD-PRTA RJ48C Connector Pin-outs shows the pin-outs for
the 8-pin RJ48C connector for the network and terminal interfaces.
Table 4-34 GCD-PRTA RJ-45 Cable Connector Pin-Outs
RJ-45 Cable Connector – CN2
T-Bus Connection
Pin No. Connection
1RA
2RB
3—
4TA
5TB
6—
7—
8—
Table 4-35 GCD-PRTA RJ48C Connector Pin-outs
Network Interface
Pin-out for the 8-Pin
RJ48C Connector
Terminal Interface
Pin-out for the 8-Pin
RJ48C Connector
Pin
No.
Connection
For connection to
T1 network: Use
AT&T Type ABAM
cable or
equivalent
(individually-
shielded twisted
pair, rated at 100
ohms at 1 MHz).
Pin
No.
Connection
1 RxD (R1) 1 RxD (R)
2 RxD (T1) 2 RxD (T)
4 TxD (R) 4 TxD (R1)
5 TxD (T) 5 TxD (T1)
3, 6 No Connection 3, 6 No Connection
7, 8 No Connection 7, 8 No Connection