NEC Univerge SV9100 - Figure 3-131 Install the Fan Access Panel; Figure 3-132 Removing CHSG LARGE BATT BOX Cover

Issue 3.0
SV9100 System Hardware Manual 3-101
6. Insert the access panel tab into the rear of the CHS2UG-US chassis
running the Battery Connection Cable through the cutout. Secure
panel with the retaining screw.
7. Connect grounding and AC power cables.
8. Apply power to chassis (refer to Chapter 4, 2.6 Powering Up the
SV9100 System on page 4-9).
8.2.4 CHSG LARGE BATT BOX Fuse Replacement
1. Loosen screw on front of CHSG LARGE BATT BOX.
Figure 3-131 Install the Fan Access Panel
Figure 3-132 Removing CHSG LARGE BATT BOX Cover