NEC Univerge SV9100 - Figure 3-149 9.5 Chassis (Rear View)

Issue 3.0
3-112 Installing the SV9100 Chassis
8.4.2 CHSG LARGE BATT BOX to 9.5” Gateway (CHS2UG GW-US) or
Base (CHS2UG B-US) Chassis Connection
1. Power down the CHS2UG GW-US or CHS2UG B-US chassis.
2. Disconnect AC power cable from rear of chassis.
3. From the back of the 9.5” chassis, remove the black plastic square
covering the two-prong battery terminal leads (refer to Figure 3-149
9.5” Chassis (Rear View)).
4. Connect one end of Battery Connection Cable to Battery Connector
on rear of 9.5” chassis.
5. Connect other end of cable to Battery Connector on rear of CHSG
LARGE BATT BOX chassis (refer to Figure 3-150 CHSG LARGE
BATT BOX to CHS2UG GW-US or CHS2UG B-US Connection on
page 3-113).
WARNING
Ensure the CHS2UG GW-US or CHS2UG B-US chassis
is powered OFF.
Figure 3-149 9.5” Chassis (Rear View)
Ground
AC Inlet
For External Battery
(12V Connection)
CHS2UG