NEC Univerge SV9100 - Table 4-19 GCD-4 LCF;GCD-8 LCF LED Indications; Table 4-20 GCD-4 LCF;GCD-8 LCF RJ-61 Cable Connector Pin-Outs

Issue 3.0
SV9100 System Hardware Manual 4-49
4.5.3 LED Indications
LED indications for the GCD-4LCF/GCD-8LCF are listed in Table 4-19
GCD-4LCF/GCD-8LCF LED Indications. Each LED is listed with its
associated function and LED and Operational status.
Refer to Figure 4-18 GCD-4LCF/GCD-8LCF Blade on page 4-47 for the
location of the LEDs on the blades.
4.5.4 Connectors
Table 4-20 GCD-4LCF/GCD-8LCF RJ-61 Cable Connector Pin-Outs on
page 4-50 show the pin-outs for the RJ-61 connector. Figure 4-18
GCD-4LCF/GCD-8LCF Blade on page 4-47 shows the location of the
connectors and the pin number locations on the GCD-4LCF/GCD-8LCF
blades.
Table 4-19 GCD-4LCF/GCD-8LCF LED Indications
LED Indication
Operation Status Remarks
Live LED
(Green)
Busy LED (Red)
On On System Initializing
–
Flash (1s) On The assignment of the unit is refused.
When you exceed the system
capacity.
When the main software version is
not matched.
Flash (1s) Trouble found during self-diagnostics.
–
Flash
(100ms)
On
Normal
Operation
A Channel is busy (use
another from CH1 ~ CHx).
–
Off
All channels are idle. –
Off
On
Unit Busy
A Channel is busy (use
another from CH1 ~ CHx).
–
Off
All channels are idle. –
Flash 100ms
(On/Off)
Downloading firmware.
–