Issue 3.0
SV9100 System Hardware Manual 7-23
4. Place the spare battery (if available) in the back section of the charger; the
BATTERY STATUS LED should turn on. (Pull the battery latch back slightly
to fit the battery in the slot.)
3.5 Powering on the Handset
To power up the handset, press and hold End until the display flashes once
(about three seconds). The handset searches for the base station or multi-cell
chain it is registered to and connects to the unit with the strongest signal.
Figure 7-23 ML440 – Insert Handset into Charger
To Next Page
Loading...
