NEC Univerge SV9100 - Figure 7-18 Install AP20 Base Station; Table 7-8 Base Station LED States and Meanings

Issue 3.0
SV9100 System Hardware Manual 7-19
Install the Base Station
1. Connect a standard Ethernet cable (Cat 5 or higher) to the Ethernet/PoE
jack on the rear of the base station.
2. Route the cable through the channel.
3. Connect the other end of the cable to your TCP/IP network.
When the base station powers on, the STATUS LED on the front briefly
lights orange and then turns off while it initializes and connects to the
network. After the base station successfully initializes and connects to the
network, the LED lights green and remains steady on (refer to Table 7-8
Base Station LED States and Meanings).
Figure 7-18 Install AP20 Base Station
Table 7-8 Base Station LED States and Meanings
Color State Meaning
Green Flickering
Stage in base flash memory rewrite at the end of the
base firmware update.
Green Steady On
All operations normal.
N/A Off
No power in unit
OR
initializing and connecting to the network.
Orange Briefly On
Powering on.
Orange Flickering
Stage in base flash memory rewrite at the end of the
base firmware update.