NEC Univerge SV9100 - Figure 5-87 Install Plastic Panels; Figure 5-88 Remove Plastic Panels

Issue 3.0
SV9100 System Hardware Manual 5-81
2. Install the Numbered Keypad Panel on the multiline
terminal. Refer to Figure 5-87 Install Plastic Panels.
5.2.7 Removal and Replacement of the BS( )-L Kit (Ten Key Kit)
The Business BS( )-L Kit (in black or white), is commonly delivered with the
UNIVERGE SV9100 multiline terminal. If required, the BS( )-L Kit can be
removed and replaced on the DT300/DT700 Series multiline terminal.
The Retro BS( )-L Kit is an optional kit available to be used with the IPK II
and IPS terminals.
5.2.7.1 Remove the BS( )-L Kit
1. Pry the right side panel from the multiline terminal (refer to
Figure 5-88 Remove Plastic Panels).
Figure 5-87 Install Plastic Panels
Desi Printer
Sheet
Line Key
Panel
Numbered
Keypad
Panel
Figure 5-88 Remove Plastic Panels
Line Key
Panel
Numbered
Keypad
Panel
Desi Printer
Sheet
Side Panel