NEC Univerge SV9100 - Figure 9-99 USB Key Error - Reporter Pro

Issue 3.0
9-118 Installing SV9100 Optional Equipment
8. On initial installation, the NEC IP/Digital Reporter Pro automatically
launches. If Reporter Pro cannot find a license dongle the following
window displays.
9. Click on the Close button.
12.6.2 Install Reporter Pro Licensing
Two methods of licensing (USB Dongle or LMS) can be used with the
SV9100 system. Follow the instructions based on the license type
purchased. Refer to 12.6.2.2 USB Dongle on page 9-118 for USB Dongle
installation.
12.6.2.1 License Manager System
This method requires the license to be loaded on the SV9100
and the application configured to retrieve license information
from the PBX.
1. From Settings select License Server.
2. Enter the IP address of your PBX, then click OK.
3. Shut down and relaunch the application.
12.6.2.2 USB Dongle
This method requires the use of a NEC IP/Digital application
security key (USB dongle shipped with the application) and
inserted when Reporter Pro is running.
1. Insert the USB dongle into an available USB port on the PC.
2. Found New Hardware is displayed then Hardware
successfully installed.
Figure 9-99 USB Key Error – Reporter Pro
TIP
If Windows does not locate the driver, browse
to the CD or download from NEC site. Drivers
are located on the CD in the Driver folder.