NEC Univerge SV9100 - Table 4-23 GCD-LTA RJ11 Cable Connector Pin-Outs

Issue 3.0
SV9100 System Hardware Manual 4-57
4.7.4 Connectors
Table 4-23 GCD-LTA RJ11 Cable Connector Pin-Outs shows the pin-outs
for the RJ-61 connector. Refer to Figure 4-20 GCD-LTA Blade on page 4-54
for an illustration showing the location of the connectors on the GCD-LTA
blade.
Table 4-23 GCD-LTA RJ11 Cable Connector Pin-Outs
RJ11 Cable Connector
DLCA: CN101 (ports 1~4)
DLCA: CN102 (ports 5~8)
Pin No. Connection
1
T4/T8 (Tip for port 4 or 8)
2
T3/T7 (Tip for port 3 or 7)
3
T2/T6 (Tip for port 2 or 6)
4
R1/R5 (Ring for port 1 or 5)
5
T1/T5 (Tip for port 1 or 5)
6
R2/R6 (Ring for port 2 or 6)
7
R3/R7 (Ring for port 3 or 7)
8
R4/R8 (Ring for port 4 or 8)
RJ11 Cable Connector
LCA: CN201 (ports 1~2)
Pin No. Connection
1–
2–
3
T2 (Tip for port 2)
4
R1 (Ring for port 1)
5
T1 (Tip for port 1)
6
R2 (Ring for port 2)
7–
8–