Issue 3.0
6-28 Installing SV9100 Cordless Telephones
4.4 Installing the Bluetooth Cordless Handset
The BCH-L (BK) UNIT is an optional device that transforms the standard
multifunction telephone into a cordless terminal. This section explains how to
transform the standard hand-set into a BCH-L (BK) UNIT. The BCH-L (BK) UNIT
cannot be connected to the DTL-2E-1, DTL-6DE-1 or DTL-12-E-1 telephones.
4.4.1 Installing the Bluetooth Handset Cradle
1. Turn multiline terminal upside down.
2. Unplug the line cord and handset cord from the multiline terminal.
Only one BCH-L (BK) UNIT can be attached to the DTL multiline
terminal.
3. Lower the tilt leg to the first position (refer to Figure 6-32 Separate Tilt
Leg from Leg Support).
4. Push the two stopper tabs through the slots to separate the tilt leg
from the leg support.
5. Lay the tilt leg and the leg support flat.
6. Press the two tabs locking the legs to the multiline terminal and pull
the legs toward you, lifting to remove (refer to Figure 6-33 Remove
Legs From Multiline Terminal on page 6-29).
Before installing or removing the BCH-L (BK) UNIT, remove
the line cord and the AC adapter from the outlet.
Figure 6-32 Separate Tilt Leg from Leg Support
To Next Page
Loading...
