Issue 3.0
4-18 Installing the SV9100 Blades
MF Signal Sender (Sends caller information to CO for E911)
Call Progress Tone Detection
C-Channel Control
Conference Circuits: 64 Channel (when built-in modem is enabled) or
96 Channel (when built-in modem is disabled)
Caller ID Receiver: 80 Channels
A load switch which is used for initial system startup, resetting the
system, or when upgrading system software
One Serial Port (NEC production use only)
One SD/SDHC Card (VM) connector
One USB Port – USB 1.1/USB 2.0
Memory size – minimum of 32MB (normally 512MB or 1GB) should
be used.
USB device power consumption is less than 200mA (1W).
One Gbit Ethernet Port for VoIP function
Background Music/EXSP Control Port
Status LED
Two Audio Input/Output Terminals
One Music On Hold External Source
High-Level Data Link Control (HDLC) Packet Processing
Real Time Clock (tolerance 30 seconds/month)
Call Control Server (ex: Conference Bridge Server, Voice Mail Server,
SIP Server, RTP Forwarding, VoCoder Conversion)
One lithium battery (CR2032) which provides battery back-up of
system data and RAM memory for approximately 30 months.
The GCD-CP10 functions provided are:
Call Control Server
Conference Bridge Server
Voice Mail Server (voice mail requires proper licensing)
SIP Server
RTP Forwarding
VoCoder Conversion
To Next Page
Loading...
