Issue 3.0
4-96 Installing the SV9100 Blades
6.2.4 LED Indications
Active LED – Green
The Active LED is controlled by the DSP and indicates the board
operational status.
Off: Power off
On: Reset
Slow Flash: Board is running but not in sync with the chassis
Fast Flash: Board is in sync with the chassis and operating normally
Busy LED – Red
On: Application problem
CompactFlash Card Activity LED – Red
CompactFlash Card Activity LED is controlled by the IDE controller
and indicates read/write activity on the CompactFlash card.
6.2.5 Connectors
Ethernet Connector
This connector is a single 10 Base-T/100 Base-T-X Mbps Ethernet
connector. This port has Auto-Medium Dependent Interface Crossover
(MDIX) to select either a straight-through or crossover Ethernet cable for
connection to a PC.
To Next Page
Loading...
