NEC Univerge SV9100 - Page 452

Issue 3.0
5-84 Installing DT Series Digital and IP Multiline Terminals
5.2.7.3 Configuring the Digital Telephone for the Ten Key Kit
1. With the telephone not plugged in and the handset on-hook,
press the 4 and 6 buttons on the numbered keypad and
connect the telephone cable.
 This places the telephone into Service Class Read/
Write (R/W) mode. The Message Waiting LED should
be On.
2. Press 2 on the numbered keypad to enter the Button Kit
mode.
 The Message Waiting LED should flash.
3. Follow the directions below for the type of keypad installed:
4. Press line key 2, 8, 14 or 20 to save to memory. The display
changes back to the Service Class R/W mode and the Red
Message Waiting (MW) LED is On.
5. Press Exit to return the telephone to idle.
5.2.7.4 Configuring the IP Telephone for the Ten Key Kit
1. Press Menu, then 0 (Config) to enter the terminal program
mode.
2. At the Login screen, enter the user name (default = ADMIN)
and password (default = 6633222) and press the OK
Softkey.
3. Press 3 for Maintenance Setting.
4. Press 4 for Adjust.
5. Press 2 for Key Kit Type.
Table 5-17 Numbered Keypad Type
Numbered Keypad Type Push
LED Indication
(2D Style Terminal)
Japan Value
01
Line 1 LED on Red
Model A Telephone
02
Line 2 LED on Red
Model B UX5000 Telephone
03
Line 1 and 2 LED on Red
Call Center
04
Line 1 LED on Green
Hotel-1
05
Line 2 LED on Green
Hotel-2
06
Line 1 and 2 LED on Green
Retirement Home
07
Line 1 LED flashing Red
Japan 32-Button
08
Line 2 LED flashing Red
Japan Economy
09
Line 1 and 2 LED flashing Red
Model A Economy
10
Line 1 LED flashing Green
Model B Economy
11
Line 2 LED flashing Green
Reserve
12
Line 1 and 2 LED flashing Green