EasyManua.ls Logo

NEC Univerge SV9100 - Page 707

NEC Univerge SV9100
740 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Issue 3.0
SV9100 System Hardware Manual 9-151
13.7 IPv6 Adapter and Concentrator Solution
NEC’s IPv6 Adapter and Concentrator solutions main objective is supporting
IPv4-only DT700 Series terminals and IPv4-only NEC SV9100 PBX in an IPv6-
only network. The solution accomplishes this objective by using SSL VPN tunnels
between the DT700 terminals and the NEC PBX. NEC offers two possible
deployment scenarios; both utilize the VPN in bridge-mode, meaning the DT700
terminal’s IP address will be in the same subnet as the LAN to which the IPv6
Concentrator is connected. Bridge-mode also means that the DT700 series
phone’s VLAN tagging and packet QoS information is retained across the VPN.
System Power
The NEC Concentrator chassis is typically mounted in a 19” rack and powered by
a standard 120vac power source.
The IP6-L Adapter snaps onto the back of NEC’s DT700 Series VoIP phones and
draws electrical power from the telephone.
Figure 9-146 GBA-L UNIT LED Display
LED Name
When 1000Mbps is
Connected
When 100Mbps is
Connected
When 10Mbps is
Connected
SPEED Display Green Lighting Red Lighting Turning Off
LED Name At LINK
ACT
(At the Data Communication)
LINK/ACT Display Green Lighting Green Blinking

Table of Contents

Other manuals for NEC Univerge SV9100

Related product manuals