Issue 3.0
SV9100 System Hardware Manual 9-155
3. Scroll down to Bridge to LAN and check the box to enable.
4. Set the Transport Protocol to listen for clients using either
IPv4 or IPv6.
5. Accept the default cipher and click Submit.
6. Under the Diffie-Hellman Parameters click the generate
new button.
7. From the configuration menu under VoIP Traversal select
Authentication and verify it is set to disabled (using
certificates only).
13.7.3 IP6-L Adapter Installation and Configuration
The IP6-L adapter snaps onto the back of an NEC DT700 Series VoIP
telephone and then connected to the telephone LAN port. The network
cable is inserted into the RJ45 port on the IPV6-L adapter.
13.7.3.1 Log into IP6-L Adapter Configuration Screen
Connect a PC to the PC port on the back of the telephone.
Launch a browser and connect to the LAN default IP Address
(192.168.3.1). This may require changing the IP address of the
PC. The user name is admin and the password is password.
The following configurations are required to support the IP6-L
Adapter.
1. WAN Settings: Select how the adapter should obtain its IPv4
or IPv6 address.
2. LAN Settings: Use the default configuration for the LAN
settings setup.
3. VPN Settings: Enter the IP Address or Domain Name of
the Concentrator used in this deployment.
When the Bridge to LAN function is enabled, the
web GUI is no longer accessible by the LAN
interface. Web GUI access can be resumed from
the WAN interface. However, the WAN firewall
is enabled by default and will drop outside
traffic.
This is a processor intensive action, which may
need to be performed during a low traffic time.
If the Concentrator needs to be reset back to
factory defaults, press the erase button three
times using a large paper clip. After 2-3 minutes
the unit should be completely booted.
To Next Page
Loading...
