Issue 3.0
SV9100 System Hardware Manual 9-177
16.5.3 Installing the IP Video Doorphone
When installing the Doorphone, the Mounting Bracket, screw and
screw cover can be removed and installed using the following
procedure:
1. The Bracket is mounted to the Wall Mounting Plate (on the wall) using
two wood screws (3.8x20mm) or two M4x25mm screws.
2. Connect LAN cable to the LAN Connector from the PoE Switch.
3. Insert the Bracket tab into the slot on top of the Main body.
4. Secure Main body and Mounting Bracket with the retaining screw.
Figure 9-174 Installing the IP Video Doorphone
❍ The Mounting Bracket, Screw and Screw Cover are
attached to the Doorphone Main Body.
❍ The Wall Mounting Plate is purchased locally by the user.
To Next Page
Loading...
