Rohde & Schwarz SMW200A - Page 1123

Remote Control Commands
R&S
®
SMW200A
1108User Manual 1175.6632.02 ─ 16
SOURce1:SWEep:FREQuency:DWELl 500 ms
// With logarithmic spacing select the step width as follows
// (steps of 10 percent of the previous frequency in each instance)
SOURce1:SWEep:FREQuency:SPACing LOG
SOURce1:SWEep:FREQuency:STEP:LOGarithmic 10PCT
// Activate the sweep
// Trigger the sweep (depending on the set mode) and query the status
SOURce1:FREQuency:MODE SWEep
// Perform a one-off RF frequency sweep
SOURce1:SWEep:FREQuency:EXECute
SOURce1:SWEep:FREQuency:RUNNing?
// 1
// the frequency sweep is running
// For manual step RF sweep use the following commands
*RST; *CLS
// Activate manual step RF sweep
SOURce1:SWEep:FREQuency:MODE MANual
// Activate the RF frequency sweep.
SOURce1:FREQuency:MODE SWEep
// Activate RF Output1.
Output1:STATe 1
// Input the frequency manually for each step
SOURce1:FREQuency:MANual 200 MHz
SOURce1:FREQuency:MANual 201 MHz
// Alternatively use the UP or DOWN commands with the set step width.
SOURce1:SWEep:FREQuency:STEP:LINear 1 MHz
SOURce1:FREQuency:MANual UP
[:SOURce<hw>]:SWEep:POWer:AMODe.......................................................................1109
[:SOURce<hw>]:SWEep:POWer:DWELl........................................................................ 1109
[:SOURce<hw>]:SWEep:POWer:MODE.........................................................................1109
[:SOURce<hw>]:SWEep:POWer:POINts........................................................................ 1110
[:SOURce<hw>]:SWEep:POWer:SPACing:MODE?.........................................................1110
[:SOURce<hw>]:SWEep:POWer:STEP[:LOGarithmic]..................................................... 1111
[:SOURce<hw>]:SWEep[:FREQuency]:DWELl................................................................1111
[:SOURce<hw>]:SWEep[:FREQuency]:MODE................................................................1111
[:SOURce<hw>]:SWEep[:FREQuency]:POINts............................................................... 1112
[:SOURce<hw>]:SWEep[:FREQuency]:SPACing.............................................................1112
[:SOURce<hw>]:SWEep:POWer:SHAPe........................................................................1113
[:SOURce<hw>]:SWEep[:FREQuency]:SHAPe............................................................... 1113
[:SOURce<hw>]:SWEep:POWer:EXECute..................................................................... 1113
[:SOURce<hw>]:SWEep[:FREQuency]:EXECute............................................................ 1113
[:SOURce<hw>]:SWEep:POWer:RETRace.....................................................................1114
[:SOURce<hw>]:SWEep[:FREQuency]:RETRace............................................................1114
[:SOURce<hw>]:SWEep:POWer:RUNNing?................................................................... 1114
[:SOURce<hw>]:SWEep[:FREQuency]:RUNNing?.......................................................... 1114
SOURce Subsystem