Migrating from an S8700 or S8710 Media Server to an S8720 Media Server
1022 Upgrading, Migrating, and Converting Media Servers and Gateways
Accessing the second S8720 Media Server
To access the second S8720 Media Server:
1. Open a browser and connect to the media server.
2. Log in. For more information, see Accessing the media server maintenance web
interface on page 953.
3. Suppress all alarms.
Confirming the product ID on the first S8720 Media Server
To confirm the Product ID:
1. Use the PuTTY application to reaccess the server using the secure shell (SSH) protocol.
2. Log in as craft or dadmin.
3. At the prompt, type productid. Press Enter.
The productid should match the value record in Obtaining the Product ID on the active
S8700 or S8710 Media Server on page 965. If value does not match, escalate the problem
immediately.
Enabling CNC, if necessary
If the CNC status in Checking the CNC status on page 957 is Control Network C has been
configured, do this procedure. Otherwise, go to Initializing Communication Manager
on
page 1022.
If using Control Network C (CNC):
● Type cnc on. Press Enter.
Initializing Communication Manager
To initialize Communication Manager:
1. Type stop -acf. Press Enter to stop Communication Manager.
2. Type start -ac. Press Enter to start Communication Manager and load the translations.
To Next Page
Loading...
