Installing or converting to an S8500 LSP
1172 Upgrading, Migrating, and Converting Media Servers and Gateways
e. Choose - Configure LSP or ESS from the list in the left margin.
● Select This is a local survivable processor (LSP)
● For the Registration address field, enter the IP address of a CLAN that the primary
controller controls. If the primary controller is an S8500 Media Server, this address can
be a processor ethernet IP address on the new primary controller.
● For the File Synchronization address at the main cluster field, enter the physical IP
address or addresses of the primary controller media servers. These addresses must
be connected to the corporate LAN. The IP address cannot be the address of a port
assigned to a control network if the control network is dedicated to the IPSI
connection. If the control network or the control networks are dedicated, the IP
address you enter is the port assigned to the corporate LAN.
● Do not complete the File Synchronization address at the alternate main cluster
field.
f. Click Change to save your changes on the Configure Interfaces Web page.
Configuring the RMB
The Remote Maintenance Board (RMB) page is under Configure Server in the Maintenance
Web Interface and is under Optional Services in the Wizard configuration process. Manually
complete all fields or verify that the IP information for the remote maintenance board was
correctly retrieved from the Electronic Preinstallation Worksheet (EPW).
Maintenance Web Interface screen for RMB
To Next Page
Loading...
