Conversion Tasks
Issue 2.1 June 2006 1063
6. Use the following steps to reset the IPSI and exit the IPSI IP Admin Utility.
a. Type telnet 192.11.13.6 to access the IPSI.
b. Enter reset.
c. Enter y in response to the warning.
d. Disconnect the laptop from the IPSI.
e. Verify that the LED display on the IPSI faceplate contains the letters I P and a filled-in V
at the bottom.
Repeat steps a
through e for each of the other new IPSIs.
Note:
Note: Clear the ARP cache on the laptop before you connect to another IPSI. To clear
the cache, enter arp -d 192.11.13.6 at the Windows command prompt.
Verifying IPSI translations
To verify IPSI translations:
1. Type list ipserver-interface. Press Enter.
2. Verify that the ISPI circuit pack(s) are translated.
The State of Health - C P E G column shows 0.0.0.0 for each healthy IPSI. If a "1" shows
in any position, you must troubleshoot the problem.
Tip:
Tip: The pattern 0.1.1.0 usually means that a cabinet type is administered
incorrectly or a connectivity problem exists, such as an incorrectly terminated
cable.
Verifying IPSI connectivity
To verify IPSI connectivity:
1. Under Diagnostics, click Ping.
2. Under Endpoints to Ping, select IPSIs with cab number (1–99) ___ carrier number ___.
3. Type the correct cabinet and carrier numbers in the text boxes.
4. Click Execute Ping.
5. Verify that the endpoints respond correctly.
To Next Page
Loading...
