Migrating from an IP600 or S8100 to an S8400 Media Server using ftp
436 Upgrading, Migrating, and Converting Media Servers and Gateways
Setting the control interface
To set the control interface:
1. Type show control interface. Press Enter.
2. Type show port 1. Press Enter to see the current settings.
3. Type set control interface ipaddr netmask, where ipaddr is the
customer-provided IP address and netmask is the customer provided subnet mask. Press
Enter.
4. Enter quit to save the changes and exit the SIPI session.
5. Telnet to 192.11.13.6 and login.
6. Enter show control interface.
The system displays the IP address, subnet mask, and default gateway information.
Verify that the proper information was entered.
7. If a default gateway is used, enter the gateway IP address with
set control gateway gatewayaddr, where gatewayaddr is the customer-provided
IP address for their gateway.
8. Enter quit to save the changes and exit the SIPI or IPSI session.
9. Telnet to 192.11.13.6 and login.
10. Use show control interface to verify the administration.
11. Type exit. Press Enter to see the changes.
To Next Page
Loading...
