Post-Upgrade tasks
Issue 2.1 June 2006 275
Post-Upgrade tasks
Note:
Note: You must use SAT commands on the active media server for the tasks Enabling
scheduled maintenance with SATon page 275 through Busying out previously
busied out trunks on page 276.
Restoring the 4600-series IP Telephone configuration file, if any
(main server only)
If you copied a 4600-series Telephone configuration file to the /var/home/ftp/pub directory prior
to the upgrade, you must restore it after the upgrade. However, before you restore the file,
ensure that you have downloaded the appropriate IP telephone firmware.
1. At the Linux command line, type cd ~ftp/pub, and press Enter.
2. At the prompt, type cp 46xxsettings.txt /tftpboot, and press Enter.
The 4600-series IP Telephone settings file is now restored to the /tftpboot directory.
Enabling scheduled maintenance with SAT
To enable scheduled maintenance.
1. Type change system-parameters maintenance and press Enter.
2. Ensure that the administration for the Start Time and Stop Time fields is the same as
before the upgrade.
Releasing MMI using SAT
To release MMI with the SAT, perform the following step:
1. Type release board UUCSS where UU is the cabinet location, C is the carrier, and SS is
the slot.
2. Press Enter to release the circuit packs that you busied out in the Busying out MMI circuit
packs with SAT for a duplicated control network only (main server only) on page 261
section.
To Next Page
Loading...
Need help?
General
