Migrating a DEFINITY Server R to an S8700-Series Media Server
792 Upgrading, Migrating, and Converting Media Servers and Gateways
2. Insert the point of a ballpoint pen, golf tee, or a similar object into the recessed push button
switch.
Note:
Note: If you pass up the letter or the number that you want, you can either (1) cycle
through all the letters or numbers to get to the one you want, or (2) reinsert, or
eseat, the circuit pack and start again.
Setting the switch ID
If you have only one system, the default switch ID is A. The second system is B, and so on. The
switch ID is not the letter that designates the media gateway or the carrier.
To set the switch ID:
1. While the display characters are flashing, press the button until the switch ID, A through J,
shows on the top character of the LED display. When the correct letter shows, stop. The
letter flashes a few times and then stops. The next character down starts to flash.
CLK
S
E
R
V
fpdlled3 LJK 022502
To Next Page
Loading...
