Introduction
Issue 2.1 June 2006 83
Upgrading Communication Manager from 2.x to 3.1
on an S8300 Media Server
Introduction
This module provides a high-level list of tasks for upgrading Communication Manager from 2.x
to 3.1 on an S8300B Media Server. The media server can be in either ICC or LSP mode.
!
CAUTION:
CAUTION: When you are upgrading the media server as a primary controller, you must
check Product Support Notice #739U for the supported upgrade paths. If you
attempt to upgrade the media server to a release that is not supported as an
upgrade path, you might corrupt the translations.
Also, you must check PSN #739U for compatibility of software loads between the
primary controller and any LSPs or ESSs. If the software loads of the primary
controller and the LSPs/ESSs are incompatible, then file synchronization
between the primary controller and the LSPs/ESSs can cause translation
corruption on the LSPs/ESSs.
To check PSN #739U, from any computer, access http://support.avaya.com.
Select Product Support Notices > View All Documents > PSN #739U.
Note:
Note: The following procedures are for an S8300B Media Server running
Communication Manager release 2.1 or higher.
To complete these tasks, you will need the following additional documents:
● Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server,
555-234-100, Issue 9, February 2006. To obtain this document, go to http://
support.avaya.com and navigate to S8300 > Installations, Migrations, Upgrades &
Configurations. Select the appropriate document.
● Administrator Guide for Avaya Communication Manager, 03-300509.
Follow the detailed procedures in Installing and Upgrading the Avaya G700 Media Gateway and
Avaya S8300 Media Server, 555-234-100, Issue 9, February 2006, for most of the tasks in this
upgrade scenario.
To Next Page
Loading...
