Avaya S8100 Series - On the second S8720 Media Server; Installing the DAL1 card in the S8720 Media Server, if necessary

On the second S8720 Media Server
Issue 2.1 June 2006 1005
Figure 70: Removing the DAL1 card
On the second S8720 Media Server
This section describes the procedures you must perform on the second S8720 Media Server.
Installing the DAL1 card in the S8720 Media Server, if necessary
If the S8720s are using hardware duplication, install the DAL1 card.
To install the DAL1 card in the S8720 Media Server:
1. Lift up on the hood latch handle and remove the access panel.
Note:
Note: Always wear an antistatic wrist strap when working inside the media server.
h3dsdalr LAO 102505
DAL1
DUP
MEMORY
RECEIVE
MODE
LINC
SYNC
TRANS
MODE
LINC
ACTIVE
2
1
3