Post-migration administration
Issue 2.1 June 2006 405
3. Type arp -d 192.11.13.6. Press Enter. This command produces one of the following
responses:
● The command line prompt displays when the cache is cleared.
● The message The specified entry was not found appears when the specified IP
address does not currently appear in the ARP cache.
4. To access the media server, type ping -t 192.11.13.6. Press Enter.
The -t causes the ping to repeat until you get a response. When you get a response, in
about 3 minutes, wait an additional 30 seconds before you go back to the Web interface.
5. To stop the ping, type ctrl c. Press Enter.
6. Close the MS-DOS window.
Logging in to the SIPI
To log in to the SIPI:
1. Type telnet 192.11.13.6. Press Enter to open the Telnet window and connect to the
SIPI
Prompt = [IPSI]:
Note:
Note: While connected to the SIPI, type help or ? to obtain online help. Most
commands have two or three letter abbreviations.
2. Type ipsilogin. Press Enter. The abbreviated command is il.
Note:
Note: The craft login used on the SIPI has a different password than the craft login used
on the media servers.
3. Log in as craft.
Prompt = [IPADMIN]:
To Next Page
Loading...
